Introduce
Motorized concrete flow table To determining the quantity of water and the standard consistence by measuring the fluidity of cement mortar.
STANDARD:BS 4551-1, 3892-1, ASTM C320
Application
It is suitable for pozzolanic Portland cement, composite Portland cement, ordinary Portland cement and slag Portland cement mixed with pozzolanic mixed materials.
Installation and commissioning
Fasten to the base with expansion bolts. The instrument base is made of concrete (or brick-concrete foundation), the size of the bottom surface is about 400mm×400mm, and the height is about 690mm. A washer should be filled between the base and the instrument frame, and the level of the desktop can be adjusted by adjusting the height of the washer. When the instrument is installed, its table top should be level when measured along both diameters at right angles to each other. After the jumping table is installed, use the fluidity standard sample for verification. If the measured fluidity value is within the specified range from the fluidity value of the given standard sample, the installation and use performance of the jumping table are qualified.
Care and Maintenance
After use, the instrument should be cleaned to remove the residual glue around the instrument, and lightly lubricate the surface of the push rod, tabletop and cam with light oil. If not used for a long time, the instrument should be protected from dust, and the controller should be placed in the box.
If the instrument does not count, please check whether the proximity switch is loose and whether the gap with the cam is 1mm~2mm. If there is any deviation or looseness, please adjust the gap and tighten it.
Structure diagram
[fusion_table fusion_table_type=”1″ fusion_table_rows=”” fusion_table_columns=”” hide_on_mobile=”small-visibility,medium-visibility,large-visibility” class=”” id=”” animation_type=”” animation_direction=”left” animation_speed=”0.3″ animation_offset=””]1. Frame 2. Proximity switch 3. Motor 4. Cam 5. Bearing 6. Push rod 7. Disc table top 8. Tamper 9. Die sleeve 10. Truncated cone die 11. Inspection gauge 12. Controller |
---|
Main Specifications
1. The total weight of the vibration part is 4.35Kg±0.15Kg
2. The drop of the vibration part is 10mm±0.2mm
3. Vibration frequency 1Hz
4. Vibration times 25 times
5. Diameter of disc table top ∮300±1 mm
6. Net weight (including accessories): 20Kg
Error: Contact form not found.
Reviews
There are no reviews yet.