stainless steel film applicator

Specification: (coating film width 80mm)

Preparation device material: high-grade stainless steel wear-resistant material

Effective coating width: 80mm; total length: 100mm CAN BE OEM

Specifications:

NO/1: (5μm, 10μm, 15μm, 20μm)

NO/2: (10μm, 15μm, 20μm, 25μm)

NO/3: (25μm, 50μm, 75μm, 100μm)

NO/4: (50μm, 100μm, 150μm, 200μm)

NO/5: (30μm, 60μm, 90μm, 120μm)

NO/6: (100μm, 200μm, 300μm, 400μm)

NO/7: (50μm, 75μm, 100μm, 150μm)

NO/8: (100μm, 150μm, 200μm, 250μm)

NO/9: (250μm, 500μm, 750μm, 1000μm)

Manual

1. Material: stainless steel

2. Hardness: HRC55±2

              Specification/Accuracy 5±1 10±2 15±2 20±2

             Specification/Accuracy 10±2 15±2 20±2 25±

             Specification/Accuracy 25±2 50±2 75±2 100±2

             Specification/Accuracy 50±2 75±3 100±3 150±3

             Specification/Accuracy 100±3 150±3 200±3 250±3

             Specification/Accuracy 250±3 500±5 750±5 1000±10

3. Purpose:

           It is used to coat wet film of specified thickness to determine the coverage rate, color and sample preparation of the sample.

4. How to use:

         Place the template on the platform, fix it, and do not move when the preparer slides over. Select the preparer according to the required wet film thickness, place it on the short side of the sample, close to parallel or at a specified position, and then place about 5ml of the sample on the front island of the preparer, hold the two ends with your fingers to 150 Sliding at a speed of mm/sec, that is, it is coated into a wet film with a required thickness. After use, wash and dry with a solvent, and coat the surface with oil.